DENTEMP LOOSE CAP & LOST FILLING REPAIR

Uses / Instructions

To Replace a Lost Filling:

• Wash hands.
• Rinse out cavity with warm water.
• Do not dry; leave moist.
• Use applicator to remove a small amount of material from vial, form into a ball with your fingers and press firmly into cavity.
• Scrape the material off your finger by scraping your finger along the edge of the tooth.
• Do not lift your finger straight up as this might loosen the material in the cavity.
• Bite down several times to insure proper bite.
• REMOVE ANY EXCESS MATERIAL.
• RINSE OUT MOUTH WELL.
• Allow two hours to set before eating.

To Re-cement Loose Caps or Crowns:

• Wash hands.
• Prepare crown by carefully removing as much old cement as possible from inside the crown.
• Rinse well.
• Clean and rinse tooth area with water and leave moist.
• Fit the crown back on the tooth before applying new material.
• Make sure it fits properly.
• If you cannot do this, DO NOT PROCEED. See your dentist.
• Use applicator to remove a small amount of material from vial.
• Place a very small amount of material along the inside edge of the open end of the crown.
• Place crown on wet tooth and press firmly.
• Bite down several times to insure proper fit.
• If the bite is not completely comfortable, remove and repeat all steps until the crown feels normal.
• REMOVE ANY EXCESS MATERIAL.
• RINSE OUT MOTUH WELL WITH WATER.
• Allow at least two hours to set before eating.
• Dentemp Losse Cap and Lost Filling Repair can be used to replace a bridge.
• Should not be used on implants or posts without dentist’s advice.